木托盤材料的要求：
Requirements for wood tray materials:
木板：嚴格的長度、寬度要求，厚度22毫米；
Board: strict length and width, thickness 22 mm;
釘子：采用具有環狀紋路的釘子，提升拉拔力;
Nails: use the nail with ring pattern to improve drawing force.
釘位：所有的托盤的釘位都一致；
Nail position: all the pallets have the same nailed position.
角塊：極端耐熱耐寒，不是誰都能提供，由通過考核的供應商提供；
Corner block: extreme heat and cold resistance, not everyone can provide, provided by the supplier through examination.
倒棱處理：保證叉車作業時貨叉出入的平滑順利。
Chamfering treatment ensures smooth and smooth entry and exit of forklift trucks.
木托盤成品的質量檢驗：
Quality inspection of wooden pallet finished products:
檢查托盤的維修檢驗工具（檢驗工具要進行度量衡校準）；
Check the maintenance and inspection tools for pallets (inspection tools should be calibrated by weights and measures).
托盤長度：2處測量，比較多允許一處數據有偏差；
Pallet length: 2 measurements, allowing at most one data deviation.
托盤寬度：2處測量，比較多允許一處數據有偏差；
Pallet width: 2 measurements, allowing at most one data deviation.
縱梁的板厚：3處測量，比較多允許一處數據有偏差；
The thickness of the longitudinal beam is measured at 3 locations, allowing at most one data deviation.
縱梁的寬度：3處測量，比較多允許一處數據有偏差；
The width of the longitudinal beam is measured at 3 locations, allowing at most one data deviation.
除縱梁外的其它的木質部件，長寬厚任一數據的測量。
Except for the other wooden parts outside the longitudinal beam, the measurement of any data is long and wide.
三維檢查，主要檢查托盤組裝是否水平。
Three dimensional inspection mainly checks whether the pallet is assembled horizontally.
在托盤發貨前用帶有緣測量針的電子濕度計進行木材的水分含量檢查。
The moisture content of the wood is checked with an electronic hygrometer with an insulating needle before the pallet is shipped.
